|
Post by switchman1 on Sept 16, 2010 20:57:36 GMT -6
Marzocchi #11 all together.......
|
|
|
Post by switchman1 on Sept 16, 2010 20:58:53 GMT -6
With the end caps off........
|
|
|
Post by switchman1 on Sept 16, 2010 21:01:14 GMT -6
Push out the gear pack....notice the burrs on the top of the "bones" these collect on the discharge side of the gear, once this happens its no good for hopping!
|
|
|
Post by switchman1 on Sept 16, 2010 21:04:01 GMT -6
Wear on the intake side......
|
|
|
Post by switchman1 on Sept 16, 2010 21:06:40 GMT -6
This is the discharged side, once the scratches reach to the top, replace the gear.......the fluid will blow by and not max out......for hopping, for lift and lay its ok.
|
|
|
Post by switchman1 on Sept 16, 2010 21:14:14 GMT -6
Careful when you bore out, this discharge orifice is really close to the pressure seal, if the o-ring is visible on the other side of this plate when its set on the block....its no good. These gear pumps were never meant to discharge out of these end caps......and were never meant to exceed 3000 psi. in hopping these gears eat away fast if you dont use a cooling "agent" in the oil.........
|
|